Studies on the use of power ultrasound in solid–liquid myrobalan extraction process

Focus on eco-friendly processing techniques makes vegetable tanning a viable option in leather processing and establishes the subsequent need for the more efficient methods of extraction in tannin manufacture. Application of ultrasound has been tried in the extraction of tannins from myrobalan nuts in order to improve the extraction efficiency, to perform the extraction under milder process conditions and to reduce the process time. The influence of process parameters such as ultrasonic output power, time and temperature has been studied. Scale-up trials and the use of ultrasound in pulse mode have also been attempted. The results show that a three- to fivefold improvement is possible with ultrasonic output from 20 to 100 W. Extraction efficiency has been calculated from the maximum extractable materials from myrobalan nuts. Extraction efficiency is found to be 90% for ultrasound, 100 W without external heating as compared to 77% for control process at 70 °C for 4 h. Therefore, ultrasound could be employed even dispensing with provision for temperature controls. The use of ultrasound in pulse mode offered 70% extraction efficiency of continuous mode. Scale-up trials indicate that there exists an optimum ultrasonic output power depending on the amount of nuts used, to achieve better extraction efficiency. The effectiveness of ultrasonically extracted tannin solution has also been tested in the tanning process for its applicability. The degree of tanning efficacy has been assessed by shrinkage temperature measurement. The results indicate that ultrasonically extracted tannin solution is suitable for tanning process. Therefore, application of ultrasound in tannin extract manufacture is a viable option with added advantages.     

渣油－水乳化液作为路面抑尘剂的研究

为了有效抑制汽车运输路面的扬尘，选择低浓度渣油－水乳化液作为抑尘剂，通过在实验室大量的试验，掌握了一组渣油乳化的最佳配方及其制备工艺，即渣油３％－６％，乳化剂约０．５％，水９３．５％－９６．５％，制备温度＞７０℃．经过室内和现场大规模试验表明，当路面喷洒量达到２．２ｋｇ／ｍ２时，其有效抑生时间达到１０ｄ以上，并且在一定程度起到养路的作用，长期使用可取得显著的综合经济效益．     

低浓度渣油-水系乳化液的抑尘性能现场试验研究

本文介绍了作者用渣油－水系乳化液做路面抑尘剂在某矿露天坑３种不同类型路面进行的大规模工业性试验。现场测定结果表明：这种路面抑尘剂可以获得比较理想的防尘效果，长期使用该乳化液可取得显著的综合经济效益。     

Determination of polychlorinated biphenyl congeners in environmental samples

Ｄｅｔｅｒｍｉｎａｔｉｏｎｏｆｐｏｌｙｃｈｌｏｒｉｎａｔｅｄｂｉｐｈｅｎｙｌｃｏｎｇｅｎｅｒｓｉｎｅｎｖｉｒｏｎｍｅｎｔａｌｓａｍｐｌｅｓ￥ＣｈｕＳｈａｏｇａｎｇ；ＹａｎｇＣｈｕｎ；ＸｕＸｉａｏｂａｉ（ＲｅｓｅａｒｃｈＣｅｎｔｅｒｆｏｒＥｃｏ－Ｅｎｖ...     

气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

非程序升温色谱法分析CO/CO2加氢反应混合物

在非程序升温单桩色谱仪上，采用双柱温法对ＣＯ／ＣＯ２加氢反应混合物进行在线分析，设置条件为３ｍ长的色谱柱ＧＤＸ－４０３，柱前压和检测温度固定不变，氢气为载气，ＴＣＤ为检测器，结果表明：在柱温３１３Ｋ，可以分析ＣＯ、ＣＨ４、ＣＯ２。在柱温３６８Ｋ，可以分析Ｈ２Ｏ和甲醇。通过计算反应前后２组物质浓度的变化，可以快速、准确评价催化剂的活性和选择性。     

国内氰化物测定法近况

阐述了近几年来国内氰化物的测定方法。方法包括:色谱法、光谱法、电化学法及其他方法。     

热解析气相色谱法测定土壤中苯系物

建立了用热解析气相色谱法测定土壤中苯系物的方法.采用保留时间定性,外标法定量.方法检出限分别为:苯1.8 μg·L-1、甲苯3.5 μg·L-1、乙苯7.0 μg·L-1、间二甲苯8.6 μg·L-1、对二甲苯8.6 μg·L-1、邻二甲苯9.8 μg·L-1、苯乙烯10.0 μg·L-1;加标回收率在79%～100%之间,相对标准偏差为1.5%～3.9%.方法操作简便,快速,灵敏度高,能适应现代化的应急监测.     

含纤维素废水生物水解的应用研究

提取植物或动物纤维所产生的高浓有机废水，含短小纤维、木质素、纤维素、半纤维素、蜡质、果胶及其分解产物(糖、脂肪酸、醇等)，较难生物处理，属含纤维素废水。试验研究和生产应用表明，生物水解对含纤维素废水中高分子有机物，可予分解并提高度水可生化性：在常温、PH约9．5时，水解池污泥浓度达6．5～16．0g/L，容积负荷达2．9kgCOD／m^3．d，COD去除率为24—36％，VFA提高3．9—5．1倍，BOD／COD提高12～16％。分析认为：中温、酸性，纤维素、木素含量低时，水解效果应更好。     

Florisil柱层析与GC-ECD测定海洋环境样品中OCPs

建立了ＧＣ－ＥＣＤ测定海洋环境样品中ＯＣＰs的分析方法。通过Ｆｌｏｒｉｓｉｌ柱层 析的分类分析和毛细管ＧＣ－ＥＣＤ的测定，得出了ＯＣＰs柱层析的分离点（所需正己烷 的最小淋洗体积为１５０ｍｌ）和ＯＣＰs的回收率（其范围为２１．８％～１０８．７％），给出了海洋环境样品中ＯＣＰs的含量。结果表明，本方法是可行的。